Leading manufacturer of court covers

Gym Floor Cover Storage

No single storage method will be right for all facilities. Size of cover sections, size and location of storage area, frequency of use, time and personnel constraints are some of the factors that should be considered. Here are some options:

Our Gym Floor Covers are specifically selected based upon your application. Call our specialists so we can design a protective system for your specific facility.

Electric Power Winder

This accessory complements the mobile storage rack by winding each cover section on its storage roller.

Mobile Storage Rack

Our Mobile Storage Rack, with special non-marring wheels, is the easy way to handle and store your cover. Each storage rack is customized to your specific needs and comes with manual hand-cranks.

 
Using one of Putterman's mobile storage racks, two people can install or retrieve a full court cover in about thirty minutes. To install, roll the rack to one corner of the surface to be protected and pull out the first cover section. Move the rack to the edge of that section and lay the second, overlapping six to twelve inches. Repeat until your surface is covered.

Tape the exposed edge of any overlaps where foot traffic is expected. The cover is taken up by attaching the last section installed to a bottom roller tube and winding it up using one of the hand cranks provided (an optional power winder is also available). Move the rack to the next section and retrieve. Repeat till done. It's important to sweep up any loose debris after each use. After sweeping, inspect for gum, dried liquids, grease, etc. - anything sticky or gritty, which can transfer to the underside of your cover - and ultimately to your floor next time the cover is used.